Quilting With Satin Stitches - Baby Lock espire BLSR Instruction And Reference Manual

e
Check the needle drop point, and then sew
along the edge of the appliqué while making
sure that the needle drops slightly off the edge
of the fabric.
a Needle drop point
CAUTION
• Be careful that the needle does not strike a basting
pin during sewing. Striking a pin can cause the
needle to break, resulting in injury.

■ Quilting with Satin Stitches

Use the foot controller to sew with satin stitches. If
you set the speed control slide to control the stitch
width, you can make subtle changes in the stitch
width during sewing.
a
Connect the foot controller (see page 41).
b
Press , and then attach presser foot "J".
c
Press in the length display to shorten the
stitch length.
Memo
A stitch length between 0.3 and 0.5 mm (approx. 1/64
and 1/32 inch) is best for satin stitches, although this
range varies depending on the type of fabric and
thickness of thread used.
d
Press .
* Change the sewing speed controller to a stitch width
controller.
e
Set "WIDTH CONTROL" to "ON". The
sewing speed will be adjusted using the foot
controller.
a
f
Press
g
While sewing, slide the sewing speed
controller to adjust the stitch width.
Memo
• Slide the controller to the left to make the width
• The stitch width is adjusted equally from the middle
a Narrower
b Wider
h
When you are finished sewing, set "WIDTH
CONTROL" back to "OFF".
SEWING THE STITCHES
.
narrower. Slide the controller to the right to make the
width wider.
(center) needle position. (Stitches Q-08 and 1-11
will adjust from the right, stitches Q-09 and 1-12 will
adjust from the left.)
a b
61
3