Avaya PARTNER ACS System Planner Manual page 45

Required Information Notes
1
Transmit/Receive CIR The Committed Information Rate (CIR) to and from the provider. Default values may be
used unless instructed by provider. Value should be the same for both voice and data
PVCs.
There are three values associated with CIR:
• Committed Burst Size (Bc)
• Circuit throughput
• Excess Burst Size (Be)
Leave each of these settings at default values unless instructed otherwise by the service
provider.
FRF.12 End-to-End Leave this setting at the default value unless instructed
1
otherwise by the service provider.
Fragmentation
1
Fragment Size Leave this setting at the default value unless instructed
otherwise by the service provider.
4. ATM PVC Settings Obtain these permanent virtual circuit settings if your SDSL provider uses the ATM protocol. Remember that separate PVC settings
are required for the voice and data connections.
1
VPI Unique Virtual Port Identifier value assigned to each
ATM connection
1
VCI Unique Virtual Circuit Identifier value assigned to each
ATM connection.
1
Encapsulation The manner in which headers are assigned to packets.
Differentiates between voice calls and data. This does
not default automatically. It must be set manually.
1
Service Category The manner in which bits are handled in the PVC.
Differentiates between voice calls and data. Defaults
automatically to UBR for PVCs using proprietary voice
encapsulation.
1. Obtained from SDSL provider
2. Obtained from ISP
3. Obtained from customer/LAN VAR
®
PARTNER Advanced Communications System
Sample values Enter values for current installation
Voice:
Enabled or Disabled
Data:
Voice:
100-1600
Data:
Voice:
32, 33
Data:
Voice:
34, 35
Data:
Proprietary Voice,
Voice: Proprietary Voice
RFC 1483
Data: RFC 1483
Voice: CBR
CBR, UBR
Data: UBR
®
PARTNER ACS 1600 DSL Module Planning Checklist
35