Barco DCS-200 User Manual page 90

4. Operation
Using the LOGO
qê~åëáíáçåáåÖ=íç=~=içÖç
To transition from the source on Program to a saved logo:
1.
L O G O S E T U P
> S e l e c t i o n
Figure 4-67. LOGO Setup Menu — Selecting a Logo
2.
3.
L O G O S E T U P
> S e l e c t i o n
Figure 4-68. LOGO Setup Menu — Logo on Program
aÉäÉíáåÖ=~=içÖç
Use the following procedure to delete a saved logo:
1.
2.
90
With an output source on Program, press the LOGO button. Please note:
~
If Menu Context is
Setup Menu automatically appears when the LOGO button is pressed.
~
If Menu Context is OFF, the Status Menu (or the current menu)
remains on when the LOGO button is pressed.
The LOGO button blinks "slow" to indicate that a logo is pending, and the LOGO
Setup Menu appears:
Press SEL and scroll to select a saved logo.
Logos appear in this list only if their resolution matches the output resolution.
Press TAKE.
The logo appears on Program and the LOGO Setup Menu displays the logo
number in brackets, as shown in the following illustration:
Note When the system transitions to the logo, the DCS-200 flip-
flops sources in the Inputs Section. Refer to the
Mode" section on page 85 for additional information.
In the LOGO Setup Menu, scroll to Selection and press SEL.
Select the logo to delete. Press SEL.
The DELETE LOGO line displays the logo number you selected.
ON (in the User Preference Menu), the LOGO
L O G O 1
[ 1024x768]
[ L O G O 3 ]
[1024x7 68]
"Flip-flop
DCS-200 • User's Guide