Barco DCS-200 User Manual page 113

Hide thumbs Also See for DCS-200:
Table of Contents

Advertisement

qêçìÄäÉëÜççíáåÖ=bíÜÉêåÉí=`çããìåáÅ~íáçå
Use the following steps to determine the IP address of the DCS-200, and establish
proper communications:
1.
2.
3.
DCS-200 • User's Guide
Power-up the DCS-200.
Note the DCS-200's current IP address:
a.
From the Status Menu, press SEL to display the Setup Menu.
b.
Select System to display the System Menu.
c.
Select Ethernet to display the Ethernet Menu.
d.
Make a note of the information on the IP line, which shows the current IP
address in all modes (with DHCP on or off).
Attempt to ping the DCS-200 as follows:
a.
Connect the DCS-200's Ethernet port to a Switch.
b.
Connect the Ethernet Switch to your PC.
c.
Turn on the PC or laptop.
d.
Open a command prompt window on the PC. Click Start > Programs >
Accessories > Command Prompt.
e.
On the command prompt line, type:
ping 192.168.0.10
... followed by Enter.
Note
Use the unit's actual IP address, as determined in step 2
above.
f.
If the computer can successfully communicate with the DCS-200, you
will see a series of "replies" from the target IP address. Repeat the
upgrade procedure as outlined in the
section on page 110.
g.
If you see a "Request timed out" message, the PC is unable to locate
the DCS-200. If this is the case:
Check your network connections and settings as described
above, or ...
Contact your network administrator, or ...
Contact Technical Support. In Appendix C, refer to the
"Contact
6. Upgrading Software
"Ethernet Upgrade
Information" section on page 160 for details.
Ethernet Upgrade Method
Method"
113

Advertisement

Table of Contents
loading

Table of Contents