Table of Contents
Advertisement
4. Operation
Using the Setup Menu
•
•
Figure 4-57. Save System Configuration Prompt
qÉÅÜ=pìééçêí
From the Setup Menu, select Tech Support to display the Tech Support Menu:
TE CH SUPP ORT
Ver s ion
Pho ne
Figure 4-58. Tech Support Menu
The Tech Support Menu displays the following information:
•
•
c~Åíçêó=oÉëÉí
From the Main Menu, select Factory Reset to display the Factory Reset Menu:
Figure 4-59. Factory Reset Menu
This function enables you to reset the DCS-200 to its factory default condition, in which all
user-defined input, output and system configuration files are deleted. When the command
is executed, a confirmation menu is shown.
82
If you do not perform the Save System State function, data will not be restored
upon the next system power up sequence.
If you make a change in the System Menu and attempt to exit the menu (by
pressing ESC) without saving changes, the system displays the following prompt:
S a v e S y s t e m C f g ?
< S E L > = Y e s
< E S C > = N o
~
Select
Yes
(SEL) to save changes.
~
Select
No
(ESC) to continue operation without saving the changes.
Version — displays the current version of installed operating firmware. This
number changes when you update system software. In Chapter 6, refer to the
"Software Upgrade
Overview" section on page 108 for update instructions.
Phone — lists the technical support phone number.
Clear All Saved
C o n fi g u ra t ion s?
< S E L > = Y e s
< E S C > = N o
01. 00
866-374-7878
DCS-200 • User's Guide
:
Advertisement
Table of Contents
