Table of Contents
Advertisement
4. Operation
Using the Setup Menu
Use the following procedure to delete a configuration file:
1.
DE LET E C O NF IG
> F i l e N u m b e r
Figure 4-33. Delete Config Menu (sample)
2.
Figure 4-34. Deleting Input Configuration Message (sample)
oÉÅ~ää=`çåÑáÖ
From the Input Menu, select Recall Config to restore a configuration file that was
previously associated with the current input. Using the Recall Config Menu shown in the
following illustration, you can change from the current configuration file for the input to any
saved configuration file:
RE CA LL C O NF IG
> F i l e N u m b e r
Figure 4-35. Recall Config Menu (sample)
A number in brackets indicates the only file that is available for recall. If no files are
available, a message will be displayed to indicate that there are no saved files.
66
From the Input Menu, select Delete Config. The menu shown in the following
illustration is displayed:
De lete F i le
The value of File Number is set to the current configuration file for the input. You
can either delete this file, select another saved configuration file and delete it, or
press ESC to continue without deleting.
Select a file to delete. Then, scroll down to Delete File and press SEL.
A confirmation message is briefly displayed, after which the system returns to the
Input Menu:
De leting I nput File
Important
You can assign a configuration file to more than one input. If
you do so, you must exercise caution when deleting the file,
because it will be deleted for all inputs.
R e c a l l F i l e
1
41
DCS-200 • User's Guide
Advertisement
Table of Contents
