Removing The Final Drive Assembly - APRILIA RS 125 Workshop Manual

CHASSIS
5.8.3.

REMOVING THE FINAL DRIVE ASSEMBLY

REMOVAL
• Remove the rear wheel, see (REMOVING THE REAR
WHEEL).
NOTE If you only need to remove the rear chain sprocket,
perform only five of the steps described here.
•
Clean the two sides of the hub with a clean cloth.
•
Remove the seal (1).
• Remove the circlip (2).
•
Unscrew and remove the five screws (3).
• Remove the rear chain sprocket (4).
•
Clean the inner part of the hub thoroughly.
NOTE Wash all components with clean detergent.
If necessary, proceed as follows:
•
Remove the rear sprocket carrier (5) and collect the
five nuts and the spacer.
• Remove the vibration damper seal (7).
REASSEMBLY
Fit the rear chain sprocket (4) and tighten the five nuts with
the sprocket carrier (5) removed from the wheel.
WARNING
Tighten in a cross pattern.
•
Refit the vibration damper seal (7) to wheel inside.
•
Refit the rear chain sprocket carrier (5) complete with
sprocket (4) to the wheel.
•
Refit the circlip (2).
• Refit the seal (1).
•
Refit the wheel, see (INSTALLING THE REAR
WHEEL).
5 - 58
RS125