Axminster TS-200 User Manual page 24

Setup & Adjustments...
W
A X M I N S T E R
W H I T E
Adjusting the Fence to the Blade
The fence (Z) can be repositioned to face the opposite direction for guiding thin timber
pieces through.
Loosen the square clamp bolt beneath the clamp assembly (N), See fig 57, turn the fence
(Z) around so the large surface of the fence is pointing away from the blade, re-attach the
fence clamp assembly (N). The two illustrations below, figs 60 & 61, shows the fence in
both positions.
Fig 60
The small surface of the fence is for
guiding thin timber through.
Adjusting the Cutting Height
Adjust the blade height with the hand wheel (F), see fig 62, so that the blade teeth are
protruding through the work piece.
Fig 62
F
Adjusting the pivot
Release the locking handle (A), the saw can be angled up to a maximum of 45˚ by turning
the hand wheel (B). (See fig 63).
NOTE: If the blade is at maximum height, it will need to be lowered by 10mm when the
pivot angle is 30˚ or more.
23
Thin Timber
www.axminster.co.uk
Z
The large surface of the fence is for
guiding thick timber through.
A
Fig 61
Thick Timber
Fig 63
Z
B