Axminster TS-200 User Manual page 14

Assembly Instructions...
W
A X M I N S T E R
W H I T E
Angle Fence Assembly (Kits: 700060, 718641)
Put to hand the work clamp block (O), and slide it onto the T-slot on the angle fence (W).
Locate the connecting block (O) and slide it onto the angle fence as before. (See fig 14).
Slide the T-bolt on the base of the connecting block (O) into the T-slot on the sliding
carriage table (D), see fig 16. Locate the plastic block (W1) and using the two phillips
screws secure it to the end of the angle fence (W) (See fig 15).
Connecting block
Locate the work clamp (C), slot the work clamp into the 20mm hole in the work clamp block
(O), secure in position with the lift and shift handle. (See figs 16 & 17). To set the angle
fence at 90˚, push the angle fence (W) up against the stop (See fig 18).
Fig 16
T-bolt
Fig 18
Note: Make sure the plastic block on the end is just missing the blade. Using a 90˚ square
check that the blade is at 90˚ to the angle fence (W), (see fig 19). When correct
tighten the lift and shift handle on the connecting block (O). (See fig 15). If the angle fence
(W) is not set to 90˚, undo the grub screw to the side of the sliding carriage table (D),
using a flat screwdriver turn the eccentric bush until the angle is correct. (See figs 20 & 21).
13
Fig 14
Work clamp block
20mm Hole
O
90˚ stop
W1
C
Fig 15
Fig 17
Fig 19