Axminster TS-200 User Manual page 13

Place an M6 x 16mm hex bolt in each of the four clearance holes on both support arms (B),
and loosely put an M6 nut and washer on the bottom of each. (See fig 8). Slide the
extruded carriage arm (V) onto the four M6 x 16mm bolts. (See fig 9).
Fig 8
M6 x 16mm bolts into each of the four
clearance holes in both support arms
Locate the sliding carriage table (D) and slide it onto the carriage arm (V), see fig 10. Using
a level or straight edge place across the sliding table (D) and the saw bench (A), fit the four
M6 x 30mm Hex bolts to the underside of the carriage support arms (B) and adjust until the
sliding table (D) is level with the saw bench. (See figs 11 & 12).
Fig 10
D
V
When both the tables are level tighten the four M6 nuts on the M6 x 16mm hex bolts
underneath the carriage arms (B), see fig 11. Lastly fit the carriage arm end stops (K) to
each end of the carriage arm (V). (See fig 13).
Fig 12
Assembling the Sliding Carriage Table (Kits: 700060, 718641)
Assembly Instructions...
V
Slide the extruded carriage arm onto the
four M6 x 16mm bolts
B
M6 x 16mm hex bolt
K
Fig 9
Fig 11
Two M6 x 30mm hex bolt
Fig 13
W
A X M I N S T E R
W H I T E
12