Axminster TS-200 User Manual page 18

Assembly Instructions...
W
A X M I N S T E R
W H I T E
Extension Table Assembly Part 2 (Kits: 700058, 718641)
Remove the plastic covers from the ends of the two extension table support arms (X), (see
fig 38). Offer up the M6 nuts to the support arms T-slots and slide the extension table (Y)
into the extension support arms (X). Push the extension table (Y) until it is flush up against
the main saw table, place six Phillips screws into the captive nut locations (a), place a level
between both tables, adjust the screws (a) until both tables are level & tighten the six M6
Phillips screws & square nuts (b) to clamp the extension table to the supporting arms.
Replace the plastic covers you removed earlier. (See figs 39,40 & 41).
Fig 38
Fig 40
Using a Phillips screwdriver level & tighten
the Phillip screws to clamp (X & Y)
Fence Assembly (Kits: 950650, 718641)
Locate the fence clamp assembly (N) and fence (Z) Slot the steel square clamp into the
T-slot to the end of the fence (Z) and tighten the bolt using a 10mm socket/spanner.
(See figs 42 & 43).
T-slot
Fig 42
17
X
Plastic Cover
a
Steel square clamp
N
T-slot
Extension table assembled
Z
Fig 39
b
a
M6 x 16 Phillip
screw & square nut
Fig 41
10mm Socket
Fig 43
Y