Installing A New Disk - LaCie 2big Spare Drive 2TB 3TB User Manual

LaCie 2big Network 2
User Manual

4.17.3. Installing a New Disk

To remove a disk:
1. The drive tray may be locked. To unlock it, use the drawer key
to turn the lock until the slot is vertical
2. Draw out the drive tray by inserting your finger into the space
behind the drive tray handle and pulling to disengage the drive
(Fig. 86).
3. Grasp the drive tray handle and carefully extract the drive
87).
To install a disk:
Replacing a drive involves two main steps, installing the new drive
and initializing the new disk on the
below).
CAUTION:
After continuous use of the LaCie 2big Network 2,
drives may be hot. Use caution when removing.
1. Carefully insert the drive tray into an empty drive bay. When the
drive tray is most of the way in and you feel resistance, press the
drive tray handle firmly until you feel the drive snap into place
and the drive tray handle is flush with the back of the 2big.
2. Use the drawer key to lock the drive.
3. In the Dashboard > RAID
ing that the system has recognized a new disk. Click the
button to continue.
4. The new disk will be added as a spare or as a part of a RAID
array and will begin to rebuild.
IMPORTANT INFO: In the event that an individual hard disk fails
in the LaCie 2big Network 2, please contact your LaCie reseller or
LaCie Customer Support. Please replace a defective hard drive only
with a new drive provided by LaCie.
• DESIGN BY NEIL POULTON
(Fig. 85).
Dashboard > RAID page (see
page, you will see a message indicat-
Administering Your LaCie 2big Network 2
(Fig.
Fig. 85
Claim
Fig. 86
Fig. 87
page 60