Replace [Y] [M] [C] [K]Toner Cartridge Or [Y] [M] [C] [K] Toner Is Low - Xerox 6250DT - Phaser Color Laser Printer Service Manual

Replace [Y] [M] [C] [K]Toner Cartridge or
[Y] [M] [C] [K] Toner Is Low
■
Print the Supplies Usage page to verify remaining life and Toner Cartridge
install date.
■
Replace the cartridge.
■
Cycle printer power.
■
If the problem persists, follow the procedure below
Note
"[Y] [M] [C] [K] Toner Is Low" is a warning condition. "Replace [Y] [M] [C]
[K] Toner Cartridge" is a hard stop error condition.
An empty cartridge or a fatal error within the cartridge or printer can cause the
hard stop condition. Check for an error code in the help text prior to
troubleshooting this error message. If a code is present in the help text, go to the
fatal error troubleshooting procedure for "Replace [Y] [M] [C] [K] Toner
Cartridge" on page 3-76.
When no jobs are being sent to the printer, an additional low toner warning
message "[Y] [M] [C] [K] Toner Cartridge Empty" will be displayed on the front
panel. This allows continued printing (Run Black) in black and white mode for a
short period of time. Once the color cartridges are empty, the message changes to
"Replace [Y] [M] [C] [K] Toner Cartridge", a hard stop.
Troubleshooting Reference Table
Applicable Parts
Toner Low Sensor, PL 10.1.5
Motor Driver Board, PL 12.1.14
Toner Cartridge Holder Assembly, PL 10.1
Troubleshooting Procedure Table
Steps Actions and Questions
Verify replacement of the Toner Cartridge
1
for the problem color.
Does the error recur after the toner
cartridge is replaced?
Error Messages and Codes
Wiring and Plug/Jack Map References
"Developer Section 1" on page 10-19
"Drive Section" on page 10-18
Yes
Go to Step 2.
No
Complete
3-45