Xerox 6250DT - Phaser Color Laser Printer Service Manual page 114

Troubleshooting Procedure Table (Continued)
Steps Actions and Questions
Remove the Tray 3 Feed Solenoid connector
16
J824;
Is J824-1 <=> J824-2 less than 100 ohms?
Verify the voltage between P/J83-11 <=> P/
17
J81-1 on the Circuit Board LTA is +24 VDC.
Check the OPT Feeder Plug Assembly to the
18
LTA Main Assembly to the Tray 3 Harness
Assembly for continuity.
See "Paper Tray 3" on page 10-29.
Error Messages and Codes
Yes No
Go to Step 17. Replace the Tray
3 Feed
Solenoid,
PL 14.4.17. or
PL 15.4.17
Go to Step 18. Replace the
Lower Feeder
Circuit Board,
PL 14.5.1 or PL
15.5.1.
Replace the Replace the
Engine Control open Harness
Board, Assembly.
page 8-107.
3-33