Table of Contents
Advertisement
• Enable: To enable the SNMPTrap settings, click on the "Enable" box in the middle of the
Settings
• Community: This is just a string authentication and can be seen as a plain text password.
3.5.5.2
SNMP Trap List
To configure the "SNMP Trap List" select the
configuration options shown in Figure 3–15 will appear.
Figure 3–15
• Host IP: The port number of the agents listening for traps. Click Add to avail agents to the
Receiver List
• Severity is the parameter used to determine what levels of events to be sent via SNMP (1, all
levels; 2, Warning and Alert; 3, only Alert).
• Host Name: A list of listening SNMP agents.
Important
Agent and NPC configuration parameters can be reconfigured later using the installation program.
Run the installation program and select Configure Only from the Start menu to reconfigure Agent
and NPC settings.
3.5.6 Broadcast Settings
To open the "Broadcast Settings" window, first open the
6, and then select the
shown in Figure 3–16 will appear. There are two sub-tabs in the
window, "Base Settings" and "Broadcasting List".
window.
SNMP Trap List Settings
.
Broadcast Settings
SNMP Trap List
sub-tab from Figure 3–14. The
NPC Settings
Broadcast Settings
sub-tab. The
Broadcast Settings
Configuration Options
SNMP
Trap
window shown in Figure 3–
configuration window
configuration
43
Advertisement
Table of Contents
