Table of Contents
Advertisement
Altos RAIDWatch User Guide
• Sender's E-mail: enter the valid e-mail address that will be used as the "From" part of event e-
• Receiver's E-mail: enter the full internet e-mail address for the receiver.
• Subject: enter a subject for notification e-mails. Currently, Subject is not available for Unix-
• Message: enter the message to be included as the e-mail event notices. Messages can be added
When you have finished, click Add to have NPC send event notification e-mail messages to this e-
mail address. Next, either enter another e-mail address to receive notices, choose another NPC item
to configure, or click Close to save changes and exit the installation procedure.
11.9 Configuring SNMP Trap Notification
Starting SNMP trap receiving capability can be as simple as keying
trap"
To enable SNMP receiving capability under Linux, you can use the
SNMP trap notification is a supported NPC function. Simply enter the IP addresses of SNMP agents
for trap notification to work.
Figure 11–7
Avail hosts to be listening to SNMP traps by entering its IP addresses and adding the addresses to
the list of trap receivers.
Users may select a severity parameter (1,2, or 3). The parameter determines events of what severity
level(s) are to be sent via SNMP.
1
154
mail notices.
based platforms.
such as the contact information of technical personnel.
at the DOS prompt under Windows-based systems.
: SNMP Trap List
All severity levels
"net start snmp"
"snmputil
and
"snmptrapd -P"
command.
Advertisement
Table of Contents
