Mute; Ccd; Recall; Input - Insignia IS-TVDVD20A User Manual

IS-TVDVD20 20-inch TV-DVD Combo.fm Page 5 Sunday, September 11, 2005 1:01 PM
IS-TVDVD20 20-inch TV/DVD Combo
Button Description

23 MUTE

Press to mute sound.

24 CCD

Press to turn closed captioning for
a TV program on or off.
25 Back up Not used with this unit.

26 RECALL

Press to change to the last
channel you viewed.
27 TIME Press to open the Time menu.

28 INPUT

Press one or more times to select
the video source (Video1, Video2,
YCbCr, TV).
29 CH +/CH – When the OSD is closed, press
the CH + or CH - button to change
the TV channel. When the OSD is
open, press to adjust options.

30 SCAN

Press to scan through the
available TV channels. Press
again to stop scanning.

31 SLEEP

Press to set the sleep timer to
automatically turn off the TV.
32 Arrows Press to make selections on the
DVD OSD or DVD menus.

33 PLAY/ENTER

When the OSD is closed, press to
start disc playback or resume
normal playback. When the OSD
is opened, press to confirm
selections.
34 D.MENU Press to open the DVD menu if
the DVD you are playing has a
menu.

35 SUBTITLE

Press to select subtitles for a DVD
if the DVD has subtitles.
36 SLOW Press to playback in slow motion.
Each time you press SLOW, the
speed changes. Press
PLAY/ENTER to resume normal
playback.

37 PROGRAM

Press to enter Program mode
when playing a disc. Use the
number pad buttons to enter the
program number you want, use
the arrow button to select START.
The program playback begins.

38 TITLE/PBC

Press to open the DVD menu if
the DVD you are playing has a
menu. Use the number pad button
to enter the item number you
want.

39 SEARCH

Press to open the Search menu.
Press again to select. Use the
number pad buttons to enter the
item number you want. Press
PLAY/ENTER to confirm you
selection.
Installing your TV/DVD
combo
Using an antenna
To enjoy a clearer picture, we recommend that
you use a CATV system or an outdoor antenna.
In different places, the suitable antenna type and
position may vary.
AC power connector
Note
We recommend that you use a 75 ohm
coaxial antenna to avoid interference.
Note To avoid interference from electrical
signals, do not bind the antenna cable
together with any electrical wires.
Installing remote control batteries
To install the remote control batteries:
1 Remove the battery cover.
2 Insert two AA batteries. Make sure that the
+/– symbols on the battery match the +/–
marks inside the battery compartment.
3 Replace the battery cover.
Tip When the remote control will not be used
for a long period of time or when the
batteries are worn out, remove the
batteries to prevent leakage.
Warning Do not throw the batteries into fire.
Dispose of used batteries as hazardous
waste.
Caution
Do not drop, dampen, or disassemble the
remote control.
www.insignia-products.com
VHF
UHF
Antenna/CATV
input
5