Zanussi ZWQ 7100 SO User Manual page 8

Problems
The washing machine
doesn't rinse or doesn't
empty :
You have found water
around the washing ma-
chine :
Wash is unsatisfactory :
The appliance vibrates, is
noisy :
The wash cycle is much
too long :
The washing machine
stops during a wash cy-
cle :
The lid doesn't open at the
end of the cycle :
The E40 error code ap-
2)
pears in the display
the "Start/Pause" pushbut-
3)
ton flashes red :
8
• the drain hose is blocked or bent,
• the drainage filter is obstructed,
• the out of balance detector has been activated : washing is unevenly distrib-
uted in the drum,
• the "Drain" programme or "Night Silence Plus" or "Rinse hold" option have
been selected,
• the height of the drainage U-piece is unsuitable.
• too much detergent has caused foam to overflow,
• the detergent is unsuitable for machine washing,
• the drainage U-piece isn't attached correctly,
• the drainage filter hasn't been put back in place,
• the water inlet hose is leaking.
• the detergent is unsuitable for machine washing,
• there is too much washing in the drum,
• the wash cycle is unsuitable,
• there isn't enough detergent.
• all packaging have not been removed from the appliance (see installation
section),
• the appliance isn't level and is unbalanced,
• the appliance is too close to the wall or furniture,
• washing is unevenly distributed in the drum,
• the load is too small.
• the water inlet filters are dirty,
• the power or water supply has been cut off,
• the motor overheating detector has been activated,
• the water inlet temperature is lower than usual,
• the foam detection security system has been activated (too much detergent)
and the washing machine has begun draining the foam,
• the out of balance detector has been activated: an extra phase has been
added to distribute washing more evenly in the drum.
• the water or electricity supply is defective,
• a Rinse hold has been selected,
• the drum shutters are open.
• the temperature inside the drum is too high,
• the lid unlocks 1 - 2 minutes after the end of the cycle.
• the lid is not closed properly.
and
Causes
www.zanussi.com