Table of Contents
Advertisement
Installation
Remove all protective packaging for transit be-
fore using for the first time. Keep in case nee-
ded for future transit: Transporting a non-se-
cured appliance may damage internal compo-
nents and cause leakages and malfunctions.
The appliance can also be damaged through
physical contact.
Unpacking
1
2
Untying
A
B
C
D
2 B
1
1
2
C
1
To install your washing machine at the same
level as surrounding furniture, proceed as
shown on picture D.
10
Water supply
Install the supplied water inlet hose at the rear
of your washing machine by proceeding as fol-
lows. Do not reuse an old hose. The water inlet
hose can not be extended. If it is too short,
please contact the after-sales service.
Open the water inlet tap. Check there are no
leaks.
Drainage
Fit the U-piece on the
A
drainage hose. Place
everything in a drainage
point (or in a sink) at a
height of between 70
and 100 cm. Ensure it
is positioned securely.
Air must be able to en-
ter the end of the hose,
to avoid any risk of siphoning.
1
The drain hose must never be stretched. If it is
too short, contact an engineer.
Electrical connection
2
This washing machine must only be connected
in single-phased 220-230 V. Check the fuse
size: 10 A for 220-230 V. The appliance must
not be connected with an extension lead or
D
multi-plug adaptor. Ensure that the plug is
earthed and that it is in accordance with current
regulations.
Positioning
Position the appliance on a flat and hard sur-
face in a ventilated location. Ensure the appli-
ance does not come into contact with the wall
or other furniture. Accurate levelling avoids vi-
brations, noise and prevents the appliance from
moving when running.
90
90
90
O
O
O
www.zanussi.com
min
max
70 cm
100 cm
Hide quick links:
Advertisement
Table of Contents
