Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Zanussi ZWQ71036SE
Summary of Contents for Zanussi ZWQ71036SE
- Page 1 User Manual GETTING STARTED? EASY. ZWQ71036SE EN User Manual Washing Machine...
-
Page 2: Safety Information
SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible for any injuries or damages that are the result of incorrect installation or usage. Always keep the instructions in a safe and accessible location for future reference. -
Page 3: Safety Instructions
Old hose sets must not be reused. • If the mains power supply cable is damaged, it must be • replaced by the manufacturer, its Authorised Service Centre or similarly qualified persons to avoid an electrical hazard. Before any maintenance operation, deactivate the appliance •... -
Page 4: Product Description
• Do not put flammable products or items that are • Disconnect the appliance from the mains wet with flammable products in, near or on the electrical and water supplies. appliance. • Cut off the mains electrical cable close to the •... -
Page 5: Control Panel Description
CONTROL PANEL CONTROL PANEL DESCRIPTION Finish In Cotton 90° 1000 Quick Cotton Prewash 60° Synthetics 40° Easy Iron Delicates Wool/Handwash 30° Rinse Refresh 20 min Drain & Spin Mix 20° On/Off On/Off button On/Off Start/Pause touchpad Programs selection touchpad Finish In touchpad Temperature selection touchpad Display Spin selection touchpad... -
Page 6: Programme Chart
PROGRAMME CHART Maximum load Programme Programme description Maximum spin Temperature range (Type of load and soil level) speed 30'@30° 2 kg A short cycle for synthetic and delicate items with 30°C 800 rpm light soil level or for items to freshen up. Cotton 7 kg White cotton and coloured cotton. -
Page 7: Consumption Values
Programme options compatibility Programme ■ ■ ■ ■ 30'@30° ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ Cotton ■ ■ ■ ■ ■ ■ ■ ■ ■ Cotton ECO ■ ■ ■ ■ ■ ■ ■ ■ ■ ■... - Page 8 Approximate Energy con- Water con- Remaining programme Programmes Load (kg) sumption sumption (li- duration (mi- moisture (%) (kWh) tre) nutes) Cotton 60°C 1,16 Cotton 40°C 0,61 56,2 Synthetics 40°C 0,45 Delicates 40°C 0,55 Wool/Handwash 0,35 30°C Standard cotton programmes Standard 60°C cot- 0,95 Standard 60°C cot- 0,65...
- Page 9 • The drum turns regularly to prevent the laundry If you set also the Extra Rinse function ( ) the creases. appliance adds two or more rinses. • The lid stays locked. You must drain the water The related indicator comes on. to unlock the lid.
-
Page 10: Before First Use
If you deactivate the acoustic signals, they continue operate when the appliance has a malfunction. BEFORE FIRST USE 1. Put a small quantity of detergent in the This removes all possible dirt from the drum and the compartment for washing phase. tub. - Page 11 INTERRUPTING A PROGRAMME AND CHANGING THE OPTIONS Touch the button You can change only some options before they operate. • The indicator of the button stops to flash and stays on. 1. Touch • The programme starts, the lid locks, the The indicator of this button flashes.
-
Page 12: Hints And Tips
• Remove the laundry from the appliance. Make 2. When the programme is completed and after a sure that the drum is empty. couple of minutes the lid lock indicator • Press the button for some seconds to goes off, you can open the lid. deactivate the appliance. -
Page 13: Care And Cleaning
– liquid detergents, preferably for low • Always start a washing programme with the temperature wash programmes (60 °C max) maximum load of laundry allowed. for all types of fabric, or special for woollens • If necessary, use a stain remover when you set a only. - Page 14 CLEANING THE DRAIN FILTER Do not clean the drain filter if the water in the appliance is hot. CLEANING THE INLET HOSE AND THE VALVE FILTER 90˚ FROST PRECAUTIONS Do this procedure also when you want If the appliance is installed in an area where the to do the emergency drain.
-
Page 15: Troubleshooting
3. Disconnect the drain hose from a sink or 8. Disconnect the appliance from the mains spigot. socket. 4. Put the ends of the drain and inlet hose in a WARNING! container. Let the water flow out of the hoses. 5. - Page 16 Problem Possible solution The appliance does not fill • Make sure that the drain hose is in the correct position. The hose with water and drain imme- may be too low. diately. The appliance does not • Make sure that the sink spigot is not clogged. drain the water.
-
Page 17: Technical Data
SERVICE After the check, activate the appliance. The programme continues from the point of interruption. We recommend the use of original spare parts. If the problem occurs again, contact the Authorised When contacting the Authorised Service Centre, Service Centre. make sure that these data are available. You can If the display shows other alarm codes. - Page 20 WWW.ZANUSSI.COM/SHOP...