Zanussi ZWQ 7100 SO User Manual

Zanussi ZWQ 7100 SO User Manual

Washing machine

Advertisement

User manual
EN
Washing machine
ZWQ 7100 SO

Advertisement

Table of Contents
loading

Summary of Contents for Zanussi ZWQ 7100 SO

  • Page 1 User manual Washing machine ZWQ 7100 SO...
  • Page 2: Control Panel

    Product description The control panel Lid handle Filter access cover Adjustable levelling feet Control panel Programme selector "Door locked" light Pushbuttons and their functions "Start/Pause" pushbutton Display "Delay start" pushbutton www.zanussi.com...
  • Page 3: Safety Information

    • Connection to the water supply must be car- • Select the Drain programme let it run until ried out by a qualified plumber. the end of the cycle. www.zanussi.com...
  • Page 4: How To Run A Wash Cycle

    • Load the washing, close the drum and the lid programme. The “Start/Pause” pushbutton of your washing machine. flashes green. If you turn the programme selector to another programme while a cycle is in progress, the ap- 1) Depending on model. www.zanussi.com...
  • Page 5 Before making any changes to the current pro- This option allows you to delay the start of a gramme, you need to pause the washing ma- wash programme by 30 minutes, 60 minutes, chine by pressing the “Start/Pause” pushbut- www.zanussi.com...
  • Page 6: Programmes Table

    Spin : A spin cycle from 500 to 1000 after a Rinse hold. 1) Reference programme for test conforming to CEI 456 standard (with Eco option). 2) Not available with Eco programme. 3) Available with programmes with wash temperatures of 40°C and higher. www.zanussi.com...
  • Page 7: Care And Cleaning

    • the water supply has been cut off, the water inlet tap is closed, • the water inlet filters are dirty, • a red tab appears on the water inlet hose The appliance fills but • the drainage U-piece is fixed too low (see installation section). empties straight away : www.zanussi.com...
  • Page 8 : • the lid unlocks 1 - 2 minutes after the end of the cycle. The E40 error code ap- • the lid is not closed properly. pears in the display the “Start/Pause” pushbut- ton flashes red www.zanussi.com...
  • Page 9: Detergents And Additives

    Height 850 mm Width 400 mm Depth 600 mm LINE VOLTAGE /FREQUENCY 220-230 V / 50 Hz POWER CONSUMPTION 2300 W WATER PRESSURE Minimum 0,05 MPa (0,5 bar) Maximum 0,8 MPa (8 bar) Connection to water supply Type 20/27 www.zanussi.com...
  • Page 10: Installation

    To install your washing machine at the same ance does not come into contact with the wall level as surrounding furniture, proceed as or other furniture. Accurate levelling avoids vi- shown on picture D. brations, noise and prevents the appliance from moving when running. www.zanussi.com...
  • Page 11 • Use an appropriate amount of detergent for consequences for the environment and human the hardness of the water, the size of the health, which could otherwise be caused by in- load and how soiled the washing is. www.zanussi.com...
  • Page 12 www.zanussi.com/shop...

Table of Contents