Installing And Accessing The Configuration Utility; Configuration Utility Modes - Alvarion BU-DS.11 User Manual

3-2
Installing and Accessing the
Configuration Utility
The Configuration Utility is provided for installation on a 3.5" diskette.
1.
Insert the provided diskette into the computer where you wish to install the
Configuration Utility.
2.
Run DS11mgr.exe.
3.
Follow all instructions until you are informed that the Utility was installed
successfully.
4.
Run the Configuration Utility from the Start menu by selecting it in the DS.11
Configuration Utility folder under Programs.

Configuration Utility Modes

There are several DS.11 Configuration Utility modes of operation; these options are
selected via the Mode menu in the configuration utility main window (shown
below). The selected mode(s) is indicated by a check mark in the menu.
♦ Unit configuration: This is the default mode and is used for setting
parameters as detailed in this manual.
♦ Firmware upgrade: Used for upgrading the embedded software in managed
units; refer to Firmware Upgrade Mode, on page 3-28 for instructions on using
this feature.
♦ Multiple configuration: Used for setting configuration parameters for more
than one unit simultaneously; refer to Multiple Unit Configuration Mode, on
page 3-30, for instructions on using this feature.
♦ Trap quick view: When set to this mode, the PC switches automatically to the
Trap Monitor tab when Unit Configuration mode is selected.
BreezeNET DS.11 Series User Manual