Processor And Heatsink - HP ML310 - ProLiant - G2 User Manual
Generation 2 server
Hide thumbs
Also See for ML310 - ProLiant - G2:
- Setup and installation manual (170 pages) ,
- User manual (123 pages) ,
- Maintenance and service manual (90 pages)
Table of Contents
Advertisement
38
HP ProLiant ML310 Generation 2 Server User Guide
Processor and Heatsink
To remove the component:
1. Power down the server.
2. Remove the access panel ("Removing the Access Panel" on page 22).
3. Disconnect the fan cable from the system board.
4. Loosen the four heatsink retaining screws.
5. Remove the heatsink fan assembly
CAUTION: Be sure that you have the current version of the
system ROM. Failure to flash the ROM with the correct version before
installing or replacing the processor causes system failure. For the most
current version of the ROM, go to the HP website
(http://www.hp.com/support).
CAUTION: Heatsink retaining screws should be removed in
diagonally opposite pairs (in an "X" pattern).
CAUTION: The pins on the processor socket are very fragile.
Any damage to them may require replacing the system board.
Advertisement
Table of Contents
