Config Link_Aggregation; To Delete Link Aggregation Group - D-Link DES-3026 - Switch Reference Manual

Example usage:

To delete link aggregation group:

DES-3026:4#delete link_aggregation group_id 1
Command: delete link_aggregation group_id 1
Success.
DES-3026:4#

config link_aggregation

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To define a load-sharing group of ports, group-id 1,master port 5 of module 1 with group members ports 5-7 plus port
9:
DES-3026:4#config link_aggregation group_id 1 master_port 5 ports 5-7,9
Command: config link_aggregation group_id 1 master_port 5 ports 5-7,9
Success.
DES-3026:4#
NOTE: group_id 3 is designed for the uplink modules only (the last two ports on the
Switch (DES-3010F/FL/G ports 9-10, DES-3018 ports 17-18, DES-3026 ports 25-26) and
can only be configured for them. Any other attempt at configuring group_id 3 with
standard 10/100 Mbps ports will result in a configuration error.
DES-3000 Series Layer 2 Switch CLI Reference Manual
Used to configure a previously created link aggregation group.
config link_aggregation group_id <value 1-3> {master_port <port> |
ports <portlist> | state [enable | disable]}
This command allows configuration of a link aggregation group that was
created with the create link_aggregation command above.
<value 1-3> − Specifies the group ID. The Switch allows up to 3 link
aggregation groups to be configured. The group number identifies each of
the groups. group_id 3 is designed for the uplink modules only (the last two
ports on the Switch (9-10, 17-18, 25-26) and can only be configured for
them.
master port <port> − Master port ID. Specifies which port (by port number)
of the link aggregation group will be the master port. All of the ports in a link
aggregation group will share the port configuration with the master port.
ports <portlist> − Specifies a port or range of ports that will belong to the
link aggregation group. Ports may be listed in only one port aggregation
group, that is, link aggregation groups may not overlap.
state [enable | disable] − Allows the user to enable or disable the specified
link aggregation group.
Only administrator-level users can issue this command. Link aggregation
groups may not overlap and must be contained on a single switch.
124