Table of Contents
Advertisement
Exchanging and Updating Data u s i n g H o t S y n c® O p e r a t i o n s
Configuring HotSync Manager for infrared
communication
Next you need to go to the HotSync Manager and specify the simulated
port used for infrared communication.
To configure HotSync Manager for infrared communication:
1.
Click the HotSync Manager icon in the Windows system tray.
2.
Make sure Local is checked on the menu.
3.
Choose Setup.
4.
Click the Local tab.
5.
In the Serial Port drop-down box, select the COM port that was given
as the simulated port in the Options tab of the Infrared Monitor.
6.
Click OK.
The HotSync Manager is now communicating with the simulated port
defined for infrared communication.
NOTE: You cannot use your HotSync cable again until you
reconfigure the HotSync Manager to communicate with the port defined
for HotSync cable synchronization.
Performing an IR HotSync operation
After you complete the steps to prepare for an IR HotSync operation it is
easy to perform the actual operation.
To perform an IR HotSync operation:
1.
In the Applications Launcher, tap the HotSync icon.
2.
Tap Local.
3.
Tap the pick list below the HotSync icon and select IR to a PC/
Handheld.
4.
Position the IR port of your organizer within a couple of inches of the
infrared port of your computer.
5.
Tap the HotSync icon to start the IR HotSync operation.
IR HotSync operations
G18 User Manual 244
Advertisement
Table of Contents
