Chapter 5: Raid Configuration; Raid Configurations; Raid Definitions - Asus P5BV-C - Motherboard - ATX User Manual

5.1

RAID configurations

The server system/motherboard comes with Intel
chipsets.
The Intel ICH7R Soutbridge chip comes with the LSI Logic Embedded SATA RAID
®
(for P5BV-C / 4L only) and the Intel
you to configure the IDE and Serial ATA hard disk drives as RAID sets.
The Marvell 88SE6145 chip is a host bus adapter chip between PCI-Express
®
and Serial ATA (SATA)/Parallel ATA (PATA) devices. It employs the latest Serial
ATA (SATA) Phy technology, operating at 1.5 Gb/s or 3.0 Gb/s. The motherboard
supports the following RAID configurations:
5.1.1

RAID definitions

RAID 0 (Data striping) optimizes two identical hard disk drives to read and write
data in parallel, interleaved stacks. Two hard disks perform the same work as a
single drive but at a sustained data transfer rate, double that of a single disk alone,
thus improving data access and storage. Use of two new identical hard disk drives
is required for this setup.
RAID 1 (Data mirroring) copies and maintains an identical image of data from one
drive to a second drive. If one drive fails, the disk array management software
directs all applications to the surviving drive as it contains a complete copy of
the data in the other drive. This RAID configuration provides data protection and
increases fault tolerance to the entire system. Use two new drives or use an
existing drive and a new drive for this setup. The new drive must be of the same
size or larger than the existing drive.
RAID 5 stripes both data and parity information across three or more hard
disk drives. Among the advantages of RAID 5 configuration include better
HDD performance, fault tolerance, and higher storage capacity. The RAID
5 configuration is best suited for transaction processing, relational database
applications, enterprise resource planning, and other business systems. Use a
minimum of three identical hard disk drives for this setup.
RAID 10 is a striped configuration with RAID 1 segments whose segments are
RAID 1 arrays. This configuration has the same fault tolerance as RAID 1, and
has the same overhead for fault-tolerance as mirroring alone. RAID 10 achieves
high input/output rates by striping RAID 1 segments. In some instances, a RAID
10 configuration can sustain multiple simultaneous drive failure. A minimum of four
hard disk drives is required for this setup.
ASUS P5BV-C Series
ICH7R and Marvell
®
Matrix Storage Manager. These utilities allow
®
88SE6145
®
5-1