Table of Contents
Advertisement
When the Disks item is highlighted, press <Enter> to select the hard disk
4.
drives to configure as RAID. The SELECT DISKS screen appears.
5.
Use the up/down arrow key to highlight the drive you want to set, then press
<Space> to select. A small triangle marks the selected drive. Press <Enter>
after completing your selection.
When the Stripe Size item is highlighted, press the up/down arrow key
6.
to select the stripe size for the RAID 5 array, then press <Enter>.
The available stripe size values range from 8 KB to 128 KB. The default
stripe size is 64 KB.
We recommend a lower stripe size for server systems, and a higher stripe size
for multimedia computer systems used mainly for audio and video editing.
7.
Key in the RAID volume capacity that you want, then press <Enter> when
the Capacity item is highlighted. The default value indicates the maximum
allowed capacity.
Press <Enter> when the Create Volume item is highlighted. This warning
8.
message appears.
9.
Press <Y> to create the RAID volume and return to the main menu or <N> to
go back to the Create Volume menu.
5-12
Port Drive Model Serial # Size Status
0 XXXXXXXXXXXX XXXXXXXX XX.XGB Non-RAID Disk
1 XXXXXXXXXXXX XXXXXXXX XX.XGB Non-RAID Disk
2 XXXXXXXXXXXX XXXXXXXX XX.XGB Non-RAID Disk
3 XXXXXXXXXXXX XXXXXXXX XX.XGB Non-RAID Disk
Select 2 to 4 disks to use in creating the volume.
[↑↓]-Previous/Next [SPACE]-Selects [ENTER]-Selection Complete
WARNING: ALL DATA ON SELECTED DISKS WILL BE LOST.
Are you sure you want to create this volume? (Y/N):
[
SELECT DISKS
]
Chapter 5: Driver installation
Hide quick links:
Advertisement
Table of Contents
