Usb Mass Storage Device Configuration - Asus P5BV-C - Motherboard - ATX User Manual

When the USB Function is set to 2 USB Ports or 4 USB Ports, the following
items appear.
USB 2.0 Controller [Enabled]
Allows you to enable or disable the USB 2.0 controller.
Configuration options: [Enabled] [Disabled]
Legacy USB Support [Auto]
Allows you to enable or disable support for legacy USB. The AUTO option
disables legacy support if there is no USB device connected.
Configuration options: [Disabled] [Enabled] [Auto]
USB2.0 Controller mode [HiSpeed]
Allows you to select the USB2.0 controller mode.
Configuration options: [FullSpeed] [HiSpeed]
BIOS EHCI Hand-Off [Enabled]
Allows yout to enable or disable the BIOS EHCI Hand-Off support function.
Configuration options: [Disabled] [Enabled]

USB Mass Storage Device Configuration

Advanced
USB Mass Storage Device Configuration
USB Mass Storage Reset Delay
Device #1
Emulation Type
USB Mass Storage Reset Delay [20 Sec]
Allows you to set the time that POST waits for the USB mass storage device after
starting unit command. Configuration options: [10 Sec] [20 Sec] [30 Sec] [40 Sec]
Emulation Type [Auto]
Allows you to select device emulation type. If set to Auto, the part of less than
530MB of USB devices is emulated as floppy disk, and the rest is emulated
as hard disk. Configuration options: [Auto] [Floppy] [Forced FDD] [Hard Disk]
[CDROM]
ASUS P5BV-C Series
BIOS SETUP UTILITY
[20 Sec]
Netac
[Auto]
Number of Seconds
POST waits for the
USB mass storage
device after start
unit command.
Select Screen
Select Item
+- Change Option
F1 General Help
F10 Save and Exit
ESC Exit
4-15