Removal - Toro Vacu Power/Lawn-Boy Medallion Models - Toro 20330 - Low Wheel Walk Power Mower Service Manual

Removal - Toro Vacu Power/Lawn-Boy
Medallion Models
Complete transmission removal on the Toro Vacu
Power/Lawn-Boy Medallion mower is quite easy and is
recommended for most self-propel system repairs.
1. Remove the spark plug lead from the engine to
prevent accidental starting. Drain the fuel and oil.
2. Place the ground speed selector in neutral. This will
make it easier to remove the speed selection cable
later.
3. Remove the two fl anged head self-tapping screws
securing the screen panel to the housing and
remove the panel (Fig. 118).
C
A. Screen panel
B. Screws
WPM Drive Systems Manual
Fig 118
C. Transmission access
cover
THREE SPEED TRANSMISSION
4. Remove the black plastic transmission cover from
the top rear of the housing.
5. Remove the two fl anged head self-tapping
screws securing the belt cover to the top of the
transmission. Pull the cable from belt guide and
remove the belt guide.
6. Remove the transmission access cover from the rear
of the housing by pressing from underneath.
7. Loosen the gear selection control cable clamp screw
until the cable comes free. Do not attempt to remove
the gear selection cable from the control arm at this
time.
8. Turn the mower onto its right side and remove the
four fl anged head self-tapping screws securing the
end caps to the housing (Fig. 119).
fi g 94
A. End cap
9. Slowly pull the transmission from the housing being
very careful not to damage the gear selection cable.
Once clear of the housing, rotate the assembly until
the cable can be safely removed.
A A
Fig 119 3428-0121
4-5