SINGLE SPEED BEVEL GEAR TRANSMISSION
7. Lift the top half of the transmission pulley off. If just
replacing the belt, push the belt into the cutting
chamber and slip the belt over the blade. Reverse
the process to install the new belt (Fig. 094).
Note: Do not get anti-seize on the belt or the drive
will slip.
If the transmission is to be removed, continue:
8. Support the back of the mower on a wood block and
remove the rear wheels (Fig. 095).
WPM Drive Systems Manual
Fig 094
MVC-292
Fig 095
MVC-294
9. Bend the trailing shield slightly in the middle and
remove it from the mower. Rotate both rear spring
arms down to disengage them from the mower
housing (Fig. 096).
10. Remove klip ring, thrust washer, pinion, key spring
and thrust washer (Fig. 097).
Fig 096
MVC-295
Fig 097
PICT-1914a
3-21