Bbc Cable Installation (Recycler/Rear Bagger); Disassembly - Toro 20330 - Low Wheel Walk Power Mower Service Manual

BBC / BOS / BCS
2. Unhook the spring and cable from the bellcrank (Fig.
202).
3. Bend the throttle control locking tab back slightly
and tap the throttle control from the control panel
with a rubber mallet. Place a piece of duct tape
over the heads of the handle and the BBC control
box mounting bolts. This will prevent control box
components from falling out of the handle during

disassembly.

4. Remove the three fl anged head screws securing the
control box halves.
5. Remove the two nylon locknuts securing the control
box to the handle and carefully remove the right
control housing half.
6-28
Fig 202 3428-0173
6. Slip the end of the BBC cable from the cable lever
and remove the cable (Fig. 203).
A. BBC cable lever
BBC Cable Installation (Recycler/Rear
Bagger)
1. Slide a new BBC cable into the BBC cable lever.
Install the end of the cable sheath in recess provided
in the left control housing half.
2. Before installing the right control housing half, make
sure that the traction and BBC ends are completely
seated in their recesses. Also make sure that the
sleeve on the upper carriage bolt passes completely
through the BBC control box components to the
handle. Finally, make sure that the roll pin in the
rocker arm passes through the hole in the control
bar. Install the right control housing half. Secure with
two nylon locknuts.
Note: The fl anged locknut fi ts on the upper carriage
bolt.
3. Install the three fl anged head screws securing the
control box halves.
Fig 203
B. BBC cable
WPM Drive Systems Manual
fi g 36