Toro 20330 - Low Wheel Walk Power Mower Service Manual page 94

BBC / BOS / BCS
3. Place a piece of duct tape over the heads of the
carriage bolts that slide through the handle and the
left control box housing. This will aid in assembly.
4. Slide the sleeve onto the upper carriage bolt making
sure that it passes through the control bar, traction
lever, and left control housing.
5. Position the control hook and torsion spring in the
rocker arm as shown in Figure 156. Secure with the
roll pin making sure that the roll pin is fl ush with the
side indicated in the fi gure. Loosely install the BBC
cable lever as indicated. When correctly installed,
the control hook and the cable lever will be engaged.
A. Control hook
B. Roll pin fl ush with
this side
6-8
Fig 156
C. Cable lever
6. Slide the rocker arm assembly over the upper
carriage bolt and sleeve making sure that the sleeve
passes through the cable lever. Also make sure that
the roll pin passes through the hole in the control
bar.
7. Release the BBC cable lever from the control hood
and install the BBC cable into the cable lever (Fig.
157).
Note: The BBC cable lever is behind the spring.
A. BBC cable lever
fi g 35
Fig 157
B. BBC cable
WPM Drive Systems Manual
fi g 36