Table of Contents
Advertisement
Install the air baffle (on page 22).
1.
Install the access panel (on page 21).
2.
Install the server into the rack
3.
Power up the server (on page 18).
4.
Remove the PCI riser cages
CAUTION:
disconnect all power cords before removing or installing the PCI riser cage.
Power down the server (on page 18).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Do one of the following:
3.
Extend the server from the rack (on page 18).
o
Remove the server from the rack (on page 20).
o
Remove the access panel (on page 21).
4.
Disconnect all cables connected to any existing expansion board.
5.
Lift the release tabs, and then rotate them 180° counterclockwise.
6.
Lift the PCI riser cage to unseat the riser boards.
7.
("Installing the server into the
To prevent damage to the server or expansion boards, power down the server, and
rack" on page 31).
Operations 23
Advertisement
Table of Contents
