Table of Contents
Advertisement
Graphics card in the secondary PCI riser cage
o
Install the air baffle (on page 22).
12.
Install the access panel (on page 21).
13.
Install the server into the rack
14.
Power up the server (on page 18).
15.
HP Trusted Platform Module option
Use these instructions to install and enable a TPM on a supported server. This procedure includes three
sections:
Installing the Trusted Platform Module board.
1.
Retaining the recovery key/password (on page 78).
2.
Enabling the Trusted Platform Module (on page 79).
3.
Enabling the TPM requires accessing RBSU
information about RBSU, see the HP website (http://www.hp.com/go/ilomgmtengine/docs).
TPM installation requires the use of drive encryption technology, such as the Microsoft Windows BitLocker
Drive Encryption feature. For more information on BitLocker, see the Microsoft website
(http://www.microsoft.com).
CAUTION:
can cause hardware damage or halt data access.
When installing or replacing a TPM, observe the following guidelines:
•
Do not remove an installed TPM. Once installed, the TPM becomes a permanent part of the system
board.
•
When installing or replacing hardware, HP service providers cannot enable the TPM or the encryption
technology. For security reasons, only the customer can enable these features.
•
When returning a system board for service replacement, do not remove the TPM from the system board.
When requested, HP Service provides a TPM with the spare system board.
("Installing the server into the
Always observe the guidelines in this document. Failure to follow these guidelines
rack" on page 31).
("HP ROM-Based Setup
Utility" on page 103). For more
Hardware options installation 76
Advertisement
Table of Contents
