Install the TPM board. Press down on the connector to seat the board
6.
page 12).
Install the TPM security rivet by pressing the rivet firmly into the system board.
7.
Install the primary PCI riser cage
8.
Install the access panel (on page 21).
9.
Install the server into the rack
10.
Power up the server (on page 18).
11.
Retaining the recovery key/password
The recovery key/password is generated during BitLocker™ setup, and can be saved and printed after
BitLocker™ is enabled. When using BitLocker™, always retain the recovery key/password. The recovery
key/password is required to enter Recovery Mode after BitLocker™ detects a possible compromise of system
integrity.
To help ensure maximum security, observe the following guidelines when retaining the recovery
key/password:
("Install the PCI riser
("Installing the server into the
("System board
cages" on page 24).
rack" on page 31).
Hardware options installation 78
components" on