Table of Contents
Advertisement
WARNING:
equipment:
Observe local occupational health and safety requirements and guidelines for manual
•
material handling.
•
Get help to lift and stabilize the product during installation or removal, especially when the
product is not fastened to the rails. HP recommends that a minimum of two people are required
for all rack server installations. A third person may be required to help align the server if the
server is installed higher than chest level.
Use caution when installing the server in or removing the server from the rack; it is unstable
•
when not fastened to the rails.
WARNING:
internal system components to cool before touching them.
WARNING:
remove the power cord to remove power from the server. The front panel Power On/Standby
button does not completely shut off system power. Portions of the power supply and some internal
circuitry remain active until AC/DC power is removed.
CAUTION:
regulating uninterruptible power supply. This device protects the hardware from damage caused
by power surges and voltage spikes and keeps the system in operation during a power failure.
CAUTION:
Operating the server in this manner results in improper airflow and improper cooling that can
lead to thermal damage.
Rack warnings
WARNING:
The leveling jacks are extended to the floor.
•
•
The full weight of the rack rests on the leveling jacks.
The stabilizing feet are attached to the rack if it is a single-rack installation.
•
The racks are coupled together in multiple-rack installations.
•
•
Only one component is extended at a time. A rack may become unstable if more than one
component is extended for any reason.
WARNING:
•
At least two people are needed to safely unload the rack from the pallet. An empty 42U rack
can weigh as much as 115 kg (253 lb), can stand more than 2.1 m (7 ft) tall, and might
become unstable when being moved on its casters.
•
Never stand in front of the rack when it is rolling down the ramp from the pallet. Always handle
the rack from both sides.
WARNING:
stabilize the rack before extending a component outside the rack. Extend only one component at
a time. A rack may become unstable if more than one component is extended.
This server is very heavy. To reduce the risk of personal injury or damage to the
To reduce the risk of personal injury from hot surfaces, allow the drives and the
To reduce the risk of personal injury, electric shock, or damage to the equipment,
Protect the server from power fluctuations and temporary interruptions with a
Do not operate the server for long periods with the access panel open or removed.
To reduce the risk of personal injury or damage to the equipment, be sure that:
To reduce the risk of personal injury or equipment damage when unloading a rack:
To reduce the risk of personal injury or damage to the equipment, adequately
Setup 30
Advertisement
Table of Contents
