Table of Contents
Advertisement
WARNING: This server is very heavy. To reduce the risk of personal injury or damage to the
equipment:
• Observe local occupational health and safety requirements and guidelines for manual
material handling.
• Get help to lift and stabilize the product during installation or removal, especially when the
product is not fastened to the rails. Hewlett Packard Enterprise recommends that a
minimum of two people are required for all rack server installations. A third person may be
required to help align the server if the server is installed higher than chest level.
• Use caution when installing the server in or removing the server from the rack; it is unstable
when not fastened to the rails.
To remove the server from a Hewlett Packard Enterprise, Compaq-branded, Telco, or a third-party rack:
Power down the server (on page 27).
1.
Extend the server on the rack rails until the server rail-release latches engage.
2.
Disconnect all peripheral cables from the server.
3.
Disconnect each power cord from the server.
4.
Remove the server from the rack.
5.
For instructions on how to extend or remove the server from the rack, see the documentation that
ships with the rack rail system.
Place the server on a sturdy, level surface.
6.
Remove the PCI riser cages
WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the
internal system components to cool before touching them.
CAUTION: To prevent damage to the server or expansion boards, power down the server,
and disconnect all power cords before removing or installing the PCI riser cage.
To remove the component:
Power down the server (on page 27).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Do one of the following:
3.
Extend the server from the rack (on page 27).
o
Remove the server from the rack (on page 30).
o
Remove the access panel
4.
If the server was just extended from the rack and expansion boards with external cabling are
5.
installed on the PCI riser cage, disconnect all cables from the expansion boards to completely
remove the cage from the server.
If expansion boards with internal cabling are installed on the PCI riser cage, disconnect all internal
6.
cables from the expansion boards to completely remove the cage from the server.
If you are removing the GPU riser cage or the two-slot PCI riser cage from the primary PCIe riser
7.
location, do the following:
Disconnect all cables connected to existing expansion boards.
a.
Loosen the captive thumbscrew on the front end of the PCI riser cage, and then remove the
b.
screws from its rear end.
("Access
panel" on page 35).
Removal and replacement procedures 31
Advertisement
Table of Contents
