Table of Contents
Advertisement
Connect the SATA cable to the rear drive cage, secure the cable in the cable clip, and then connect
c.
the cable to the system board.
Install the primary PCI riser cage.
d.
Connect the rest of the drive cables required in this drive configuration. For more information, see
10.
"Storage cabling (on page 82)."
Install the drives
11.
CAUTION:
all bays are populated with either a component or a blank.
Install the access panel (on page 21).
12.
Install the server into the rack
13.
Power up the server (on page 18).
14.
Installing a 2 SFF rear drive cage option
Power down the server (on page 18).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Do one of the following:
3.
Extend the server from the rack (on page 18).
o
Remove the server from the rack (on page 20).
o
Remove the access panel (on page 21).
4.
("Drive
options" on page 34).
To prevent improper cooling and thermal damage, do not operate the server unless
("Installing the server into the
rack" on page 31).
Hardware options installation 39
Advertisement
Table of Contents
