Installation Notes; Common Problems - Intel SCB2ATA Quick Start Manual

Installation Notes

nstallation Process Quick Reference
I
Step
Install the primary processor
Install the processor terminator
(or second processor)
Install memory
Remove the access cover
Install the I/O shield
Rearrange the standoffs
Install the server board
Connect cables to the server board
Finish setting up your chassis

Common Problems

The system does not boot or show video at power on.
•
If configuring with only one processor verify that the processor is in the
Primary Processor socket and a terminator is in the Secondary Processor
socket. (See the Server Board Components diagram on page 5).
•
Beep code 1-3-3-1 means you have unrecognized or bad memory. Remove
and replace DIMMs one at a time to isolate which one is causing problems.
DIMMs must be populated in pairs.
•
Your power supply must provide 0.8 A of +5 V Standby current to support
WOL. If the standby current is not present, your board will not boot.
The system sometimes works, but is exhibiting erratic behavior.
•
This is typically the result of using an under-powered power supply. Make
sure you are using at least a 250 W power supply.
4
Where the information is located
This guide
This guide
This guide
Your chassis manual
This guide
This guide
This guide
This guide and your chassis manual
Your chassis manual
Intel Server Board SCB2 Quick Start Guide