Table of Contents
Advertisement
Installation Procedures
Install the I/O Shield
✏
NOTE
An ATX 2.03-compliant I/O shield is provided with the server board. The
shield is required by Electromagnetic Interference (EMI) regulations to
minimize EMI. If the shield does not fit the chassis, obtain a properly
sized shield from the chassis supplier. The I/O shield does not support
the use of the USB 2 connector.
The shield fits the rectangular opening in the back of a chassis. The shield has
cutouts that match the I/O ports.
1
Install the shield from inside the chassis. Orient the shield so that the
cutouts align with the corresponding I/O connectors on the server board.
Make sure the metal fingers are on the inside of the chassis.
2
Position one edge (A) so that the dotted groove is outside the chassis wall,
and the lip of the shield rests on the inner chassis wall.
3
Hold the shield in place, and push it into the opening (B) until it is seated.
Make sure the I/O shield snaps into place all the way around.
B
8
A
Intel Server Board SCB2 Quick Start Guide
OM12162
Advertisement
Table of Contents
