Removing A Processor; Installing A Pci Card - Intel S3420GPRX User Manual

Removing a Processor

1. Observe the safety and ESD precautions in
2. Turn off all peripheral devices connected to the server.
3. Turn off the server.
4. Remove the AC power cord from the server.
5. Remove the server's cover. See the documentation that came with your server
chassis for instructions on removing the server's cover.
6. Loosen the four captive screws on the corners of the heatsink.
7. Twist the heatsink slightly to break the seal between the heatsink and the processor.
8. Lift the heatsink from the processor. If it does not pull up easily, twist the heatsink
again. Do not force the heatsink from the processor. Doing so could damage the
processor.
9. Lift the processor lever.
10. Raise the CPU load plate.
11. Remove the processor.
12. If installing a replacement processor, see
install the protective socket cover over the empty processor socket and reinstall the
chassis cover.

Installing a PCI Card

This system does not include peripherals and add-in cards; you must purchase them
separately. The riser card at PCI slot 6 of the board supports a low-profile, half-length PCI
Express* add-in card. Refer to the SR1630GPRX/SR1630HGPRX System Service Guide
for more detailed information on how to install a PCI card.
Note: You must attach add-in cards to a riser card when the riser card is removed from the
chassis.
1. Remove the screw that attaches the PCI bracket shield to the rear of the chassis to
remove the shield. Retain the screw.
28
"Safety Information".
"Installing the Processor". Otherwise,
Intel® Server Board S3420GPRX User Guide