Setting The Bios Configuration Jumper; Bios Configuration Jumper Block Location (The D815Eea2 Board Is Shown); Jumper Settings For The Bios Setup Program Modes - Intel D815EEA2 - Desktop Board Motherboard Product Manual

Intel Desktop Boards D815EEA2, D815EPEA2, D815EFV, and D815EPFV Product Guide

Setting the BIOS Configuration Jumper

CAUTION
Always turn off the power and unplug the power cord from the computer before changing the
jumper. Moving the jumper with the power on may result in unreliable computer operation.
3 1
J9G2
Figure 26. BIOS Configuration Jumper Block Location (the D815EEA2 Board Is Shown)
This three-pin jumper block, shown in Figure 26, enables all desktop board configurations to be
done in BIOS Setup. Table 7 shows the jumper settings for the Setup program modes.
Table 7.

Jumper Settings for the BIOS Setup Program Modes

Function/Mode Jumper Setting
Normal 1-2
Configure 2-3
Recovery None
48
Configuration
The BIOS uses current configuration information and passwords
3 1
for booting.
After the POST runs, Setup runs automatically. The maintenance
3 1
menu is displayed.
The BIOS attempts to recover the BIOS configuration. A recovery
3 1
diskette is required.
OM11628