Installing The Desktop Board; Location Of The Mounting Screw Holes For The D815Eea2 And D815Epea2 Boards - Intel D815EEA2 - Desktop Board Motherboard Product Manual

Intel Desktop Boards D815EEA2, D815EPEA2, D815EFV, and D815EPFV Product Guide

Installing the Desktop Board

Refer to your chassis manual for instructions on installing the desktop board. Seven screws for the
D815EEA2 and D815EPEA2 boards and six screws for the D815EFV and D815EPFV boards
secure the desktop board to the chassis. Figure 11 and Figure 12 respectively show the locations of
the mounting screw holes.
✏
NOTES
You will need a Phillips (#2 bit) screwdriver.
Refer to Appendix B for regulatory requirements and installation instructions and precautions.
CAUTION
Only qualified technical personnel should attempt this procedure. Disconnect the computer from
its power source before performing the procedures described here. Failure to disconnect the
power before you open the computer can result in personal injury or equipment damage.
Figure 11. Location of the Mounting Screw Holes for the D815EEA2
34
and D815EPEA2 Boards
OM11625