Installing And Replacing Desktop Board Components; Before You Begin - Intel cc820 Product Manual

2 Installing and Replacing Desktop Board
Components
This chapter tells you how to:
•
Install and remove the AGP card and retention mechanism
•
Install and remove memory
•
Install and remove the desktop board
•
Install the processor retention mechanism
•
Install the processor
•
Replace the battery
•
Connect the IDE cable
•
Clear passwords
•
Set the BIOS configuration jumper

Before You Begin

CAUTION
Before you install this desktop board in a chassis, see Appendix B for regulatory requirements and
precautions.
•
Always follow the steps in each procedure in the correct order.
•
Set up a log to record information about your computer, such as model, serial numbers,
installed options, and configuration information.
•
Electrostatic discharge (ESD) can damage components. Perform the procedures described in
this chapter only at an ESD workstation using an antistatic wrist strap and a conductive foam
pad. If such a station is not available, you can provide some ESD protection by wearing an
antistatic wrist strap and attaching it to a metal part of the computer chassis.
WARNINGS
The procedures in this chapter assume familiarity with the general terminology associated with
personal computers and with the safety practices and regulatory compliance required for using
and modifying electronic equipment.
Disconnect the computer from its power source and from any telecommunications links,
networks, or modems before performing any of the procedures described in this chapter.
Failure to disconnect power, telecommunications links, networks, or modems before you open
the computer or perform any procedures can result in personal injury or equipment damage.
Some circuitry on the desktop board can continue to operate even though the front panel power
button is off.
21