Attach The Hinge Assembly And Catch Assembly - HP D7171A - NetServer - LPr Manual

Chapter 2

Attach the Hinge Assembly and Catch Assembly

Use this procedure to attach the hinge assembly and catch assembly to the LC
2000 pedestal.
1. Remove the hinge assembly and catch assembly from the packaging
material.
2. Line up the hinge assembly with the left side of the LC 2000.
3. Push back to insert the mounting prongs on the hinge assembly bracket
into the slots in the side of the server.
4. Install and tighten the two Phillips screws as shown in Figure 2-7.
Follow steps 3 and 4 to attach the catch mechanism on the right side of the
LC 2000.
Figure 2-7. Attaching the Hinge Assembly and Catch Assembly
16
Rack Mounting the HP NetServer