HP D7171A - NetServer - LPr Manual page 25

Chapter 2
11. Take the handles off the NetServer and store the handles and screws in a
convenient place. See Figure 2-11.
The handles can be re-attached whenever you remove the NetServer from
the rack. If moving the NetServer elsewhere, always package it with the
handles attached.
12. Press in the release latches on each slide, and push the NetServer all the
way into the rack. See Figure 2-12.
The blue Slide Release buttons in the Bezel moldings on each side of
chassis' front edge must click into the latches in the column adapters on the
two front rack columns.
Figure 2-12. Pressing in the Release Latches
13. Verify the NetServer will slide all the way into the rack, before continuing
with the procedures.
14. Go to "Attaching the Cable Management Arm" before securing the HP
NetServer in the rack.
Rack Mounting the HP NetServer
21