HP D7171A - NetServer - LPr Manual page 24

Chapter 2
7. Lower the NetServer onto the slide members. See Figure 2-10.
The handles will temporarily support the NetServer on the slides.
8. Adjust the NetServer's position on the slide members to line up the
mounting holes on each side (3 each) of the chassis with the screw holes in
the slide members.
Figure 2-11. Removing the Mounting Handles
9. Insert the flathead screws into the slides' holes at the rear and the panheads
screws in the other four places to secure the chassis to the slides.
10. Use a T-15 Torx driver to remove the screws holding the handles to the
NetServer. See Figure 2-11.
20
Rack Mounting the HP NetServer