HP D7171A - NetServer - LPr Manual page 19

Chapter 2
7. With the slide pushed firmly into position, insert two screws through the
slide's front bracket into the captive nuts on the left column adapter.
a. Secure the screws only loosely at first, so the bracket can settle into the
lowest possible position. There is a dimple in the bracket to position
the slides in the proper location.
b. Then tighten the screws until the bracket is held firmly to the column
adapter and rack column. See Figures 2-5 and 2-6.
8. Fasten the slide's rear bracket to the rack nuts on the left-rear column.
a. Secure the screws only loosely at first, so the bracket can settle into the
lowest possible position. There is a dimple in the bracket to position
the slides in the proper location.
b. Then tighten the screws until the bracket is held firmly to the column.
9. Attach the other slide to the right-front column adapter and right-rear rack
column by repeating Steps 2 through 8.
Rack Mounting the HP NetServer
15