Attaching The Front Bezel - HP D7171A - NetServer - LPr Manual

Chapter 2

Attaching the Front Bezel

The front bezel attaches to the HP NetServer by a hinge on the left and a catch on
the right. The hinge has three spring loaded hinge pins to secure the bezel. The
bezel is held in place on the right with a catch allowing the bezel to swing open
when pulled from the right. The chassis is shipped with the bezel hinge and latch
in place. The column adapters are the only items requiring installation on the rack,
which is done before mounting the rack slides.
1. Position the Bezel in front of the HP NetServer LC 2000r as shown in
Figure 2-15.
Blue Tab
Hinge Pins (3)
Figure 2-15. Hinge Pins and Blue Tab Release
24
Rack Mounting the HP NetServer
Slide Securing Screws(2)