Table of Contents
Advertisement
Default Tx Key
Encryption Key 1
to 4
Enable 802.1x
Authentication
After you finish with setting, click 'Apply', and the following message will
be displayed:
When you see this message, the settings you made are successfully saved.
You can click the 'Continue' button to return to the previous page and
modify other settings, or click the 'Apply' button to restart the wireless
range extender. The changes will take effect after about 30 seconds.
You can set up to four sets of WEP key, and you
can decide which key is being used by default here.
If you don't know which one you should use,
select "Key 1".
Input WEP key characters here, the number of
characters must be the same as the number
displayed at "Key Format" field. You can use any
alphanumerical characters (0-9, a-z, and A-Z) if
you select 'ASCII' key format, and if you select
"Hex" as key format, you can use characters 0-9,
a-f, and A-F. You must enter at least one encryption
key here, and if you entered multiple WEP keys,
they should not be same with each other.
Check this box to enable 802.1x user
authentication.
31
Advertisement
Table of Contents
